Probably a dumb question. 2000 bobcat 873 with oil cooled Deutz. Injectors were bad so I replaced them all. Now it won't start, bled the fuel but diesel is leaking from the base. (Nozzles)
I'm thinking I didn't seat the injectors correctly. They're already tight though I am afraid to hammer them down.
Is there a procedure for this?
Edit: looked at it again and they're seated but they're leaking from the metal fuel lines. I found an air leak from the return lines maybe this is causing the Now no start?
I replaced the 4 due to smoke and hard start, now it won't start at all.
Fuels getting to the injectors
I'm thinking I didn't seat the injectors correctly. They're already tight though I am afraid to hammer them down.
Is there a procedure for this?
Edit: looked at it again and they're seated but they're leaking from the metal fuel lines. I found an air leak from the return lines maybe this is causing the Now no start?
I replaced the 4 due to smoke and hard start, now it won't start at all.
Fuels getting to the injectors
Last edited:
