Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
grease zerk
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="merlynr" data-source="post: 79089" data-attributes="member: 10347"><p>I've had a S185 since last winter and I couldn't get the one tilt on bucket to take grease and the other day I took the zerk out and cleaned a bunch of hard dirt/grease out of it and put it back in an still could not get any grease thru to the bushing. Upon further investigation there was no hole in the bushing for grease to go. So I pulled the pin out and the hole was 5/8" from aligning with bushing hole. For a quick fix I decided to drill another hold in the bushing. I got it drilled but dulled about ten bits of several sizes to get thru a less than 1/8" bushing. about half of the bits were new and the rest were sharpened. What the he!! is that bush made of cause it center punched easy?</p></blockquote><p></p>
[QUOTE="merlynr, post: 79089, member: 10347"] I've had a S185 since last winter and I couldn't get the one tilt on bucket to take grease and the other day I took the zerk out and cleaned a bunch of hard dirt/grease out of it and put it back in an still could not get any grease thru to the bushing. Upon further investigation there was no hole in the bushing for grease to go. So I pulled the pin out and the hole was 5/8" from aligning with bushing hole. For a quick fix I decided to drill another hold in the bushing. I got it drilled but dulled about ten bits of several sizes to get thru a less than 1/8" bushing. about half of the bits were new and the rest were sharpened. What the he!! is that bush made of cause it center punched easy? [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
grease zerk
Top