Jeffscarstrucks
Well-known member
- Joined
- Nov 24, 2007
- Messages
- 92
I picked up a factory Bobcat set of forks that need some repair. The frame work is no problem but about an inch is broken off of one of the forks. I am trying to figure out the best way to add material and repair this. I am going to keep these around for some time and don't want to second guess myself every time I look at them. I have the MIG or TIG capability to do the repair but the composition of the fork material is what I am not sure of. Any input would be great. I also asked this question on Millerwelds. There used to be some good big equipment guys over there but I have not seen them for a while. Thanks as always, JEFF