Reply to thread

Message: <blockquote data-quote="Fishfiles" data-source="post: 10565" data-attributes="member: 782"><p>I think Ken's idea of welding something to it is the best easiest way once it is stripped out , I have broke a few allen sockets befor on that plug -------before I'd go grease I would go with some Lucas hub oil , very sticky creeping oil , it will stay in there a lot better than 90wt , the grease thing I have also done on planetaries of excavator travel motors when the seal is gone and seen them still going with grease ---------you said" all it does is lube the gears ", did you know there are 4 bearings in the blower housing assembly , 2 bearings in each half , the whole case don't hold but about 8 ozs of oil , they use to sell the bower box in two halves and you had to bolt them together before installing it , the last one I bought a few months back was only sold as 1 piece ----------as afar as whats the best grease , there are so many different types nowdays I am sure there are a few that would surfice , I have always been partial to moly , especially if it is on something that I own</p></blockquote><p></p>