Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
General Skidsteer & Technical Topics
Shop Talk
cold weather hyraulic fluid
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="skidsteer.ca" data-source="post: 40957" data-attributes="member: 307"><p>The light comes on from the oil not flowing through the filter fast enough because it is too thick. Just let the engine idle and the oil will warm as it circulates and the light will go off. Right after that it will likely come on again if you rev it up some. Slow increase the speed until you have 1/4 throttle or so, then drive the machine around a bit to move the warmer oil through the wheel motor, then start working your cylinders. If it takes more then 5 minutes to get the light out I would look for a thinner oil.</p><p>Ken</p></blockquote><p></p>
[QUOTE="skidsteer.ca, post: 40957, member: 307"] The light comes on from the oil not flowing through the filter fast enough because it is too thick. Just let the engine idle and the oil will warm as it circulates and the light will go off. Right after that it will likely come on again if you rev it up some. Slow increase the speed until you have 1/4 throttle or so, then drive the machine around a bit to move the warmer oil through the wheel motor, then start working your cylinders. If it takes more then 5 minutes to get the light out I would look for a thinner oil. Ken [/QUOTE]
Verification
Post reply
Forums
General Skidsteer & Technical Topics
Shop Talk
cold weather hyraulic fluid
Top
