New member, first post. I have searched the forum, didn't see anything that gave me any new ideas. So here's the story, I'll try to be detailed-
I purchased this 2021 C332 approximately 3 weeks ago. It has 375 hours, and I knew the entire history of it. When I went to look at it, she had just put a new battery in it a few operating hours previous. That wasn't the problem, it had blown a 2 amp fuse that was the problem. While I was test driving it, the camera became flaky and went blue screen. We called the dealership, they recommended replacing the camera, "that's always the problem". Got it home, replaced the camera, that wasnt the problem. Returned camera. Noticed that if I wigged the coax by the cab lift support, I thought it would change. Dealership recommended pulling the monitor so I could ohm wires out. So yesterday I removed the monitor, ohm'ed wires, and found no problems.
Reinstalled monitor, now the machine has no power for the display or operator panels. I have checked all the fuses in the 2 blocks under the seat, checked grounds, turned off battery disconnect overnight to see if power needed reset. I'm at a loss. It's like it doesn't know it's supposed to power up. It was fine before I removed the display monitor, except for the camera problem.
Sorry for the long post, just wanted to be thorough. Thanks in advance for any advice/assistance!
I purchased this 2021 C332 approximately 3 weeks ago. It has 375 hours, and I knew the entire history of it. When I went to look at it, she had just put a new battery in it a few operating hours previous. That wasn't the problem, it had blown a 2 amp fuse that was the problem. While I was test driving it, the camera became flaky and went blue screen. We called the dealership, they recommended replacing the camera, "that's always the problem". Got it home, replaced the camera, that wasnt the problem. Returned camera. Noticed that if I wigged the coax by the cab lift support, I thought it would change. Dealership recommended pulling the monitor so I could ohm wires out. So yesterday I removed the monitor, ohm'ed wires, and found no problems.
Reinstalled monitor, now the machine has no power for the display or operator panels. I have checked all the fuses in the 2 blocks under the seat, checked grounds, turned off battery disconnect overnight to see if power needed reset. I'm at a loss. It's like it doesn't know it's supposed to power up. It was fine before I removed the display monitor, except for the camera problem.
Sorry for the long post, just wanted to be thorough. Thanks in advance for any advice/assistance!
