Well it was finally time to pull it in the garage and give the machine some much needed TLC. My intention is to repair and restore it to proper and reliable working condition, and pretty it up with some paint but I think I opened a can of worms here.
The lift arms seem to have a bit of a bend/twist to them and they have obvious past repairs.
My question is, should the lift arms be perfectly parallel through the entire length right down to the lower tilt pin?
Thanks
Tom.
The lift arms seem to have a bit of a bend/twist to them and they have obvious past repairs.
My question is, should the lift arms be perfectly parallel through the entire length right down to the lower tilt pin?
Thanks
Tom.
