Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bics system/seat sensor
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="skidsteer.ca" data-source="post: 3510" data-attributes="member: 307"><p>300 is just for a green push button that replaces the seat switch.</p><p>There are 2 things I'd try. Remove your seat bar sensor and "Shoo Goo" the magnet that activates the sensor in the position it should be in when you are seated. Your bics lite will come on when you position it properly. Key must be on</p><p>Or 2</p><p>Located you safety valve and on it will be a coil with 2 wires cominng from it. hook one wire to ground and hook the second to switched power so it is only hot when the key is on. If you shut off th engine you will have the safety valve protection. With this methos you will have to press the "traction lock override" button to release the park brake/pin. But if you put in the 300 kit you will have to push the green "go" button anyway.</p><p>Ken</p></blockquote><p></p>
[QUOTE="skidsteer.ca, post: 3510, member: 307"] 300 is just for a green push button that replaces the seat switch. There are 2 things I'd try. Remove your seat bar sensor and “Shoo Goo” the magnet that activates the sensor in the position it should be in when you are seated. Your bics lite will come on when you position it properly. Key must be on Or 2 Located you safety valve and on it will be a coil with 2 wires cominng from it. hook one wire to ground and hook the second to switched power so it is only hot when the key is on. If you shut off th engine you will have the safety valve protection. With this methos you will have to press the “traction lock override” button to release the park brake/pin. But if you put in the 300 kit you will have to push the green “go” button anyway. Ken [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bics system/seat sensor
Top
