Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
Kubota/Wacker Neuson/Hesston/IH/Ford/Other
A hello and quick into.. and a question..
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Gremlin" data-source="post: 113593" data-attributes="member: 5888"><p>What a scary piece of equipment that servo is!. I finally got it off and the bearing is as sloppy as hell, will see if i can track one down to replace it. Pintel shafts seem free and solid to move . The servo ram i will have tested to see if it is bypassing by the local hydro shop. from the drivers seat the left one is moving 50mm total travel and the right hand side moves 60mm so there is a discrepancy there to start with. I see that they have adjustable travel in the back half of the cylinder adjustable stops for both forwards and back shaft travel. From what i can understand these get hydraulic pressure from one of the two electric motors just behind the drivers seat down low... so that add another thing in the mix that may not be operating correctly. I am also highly suspect to the main vale control unit that lives under the "T" handle, have you pulled yours apart? and does it have serviceable seals/ "O" rings in it? Mike.</p></blockquote><p></p>
[QUOTE="Gremlin, post: 113593, member: 5888"] What a scary piece of equipment that servo is!. I finally got it off and the bearing is as sloppy as hell, will see if i can track one down to replace it. Pintel shafts seem free and solid to move . The servo ram i will have tested to see if it is bypassing by the local hydro shop. from the drivers seat the left one is moving 50mm total travel and the right hand side moves 60mm so there is a discrepancy there to start with. I see that they have adjustable travel in the back half of the cylinder adjustable stops for both forwards and back shaft travel. From what i can understand these get hydraulic pressure from one of the two electric motors just behind the drivers seat down low... so that add another thing in the mix that may not be operating correctly. I am also highly suspect to the main vale control unit that lives under the "T" handle, have you pulled yours apart? and does it have serviceable seals/ "O" rings in it? Mike. [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
Kubota/Wacker Neuson/Hesston/IH/Ford/Other
A hello and quick into.. and a question..
Top