Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
Kubota/Wacker Neuson/Hesston/IH/Ford/Other
A hello and quick into.. and a question..
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Gremlin" data-source="post: 113505" data-attributes="member: 5888"><p>OK back in Brisbane. So my knowledge grows, both the servo rams and move on the brackets and seem only to "twitch" when trying to get reverse. that is the first repair i shall do when time permits next week. I would think if they are by-passing it would fail to travel forwards as well as backwards. it moves forwards , however seems slightly slower than it used to be, but that could just be me. ' Any clue to how far these rams should travel? Let me just go and measure how much shaft is exposed in the standing position. Right 35mm from the seal to the start of the flats on the shaft. That tells me these cylinders move about 18mm in either direction. I have easy 10mm movement in the mountings so over 50% of the actual movement is lost in slop alone. So i think this should be fixed as Step one. Mike</p></blockquote><p></p>
[QUOTE="Gremlin, post: 113505, member: 5888"] OK back in Brisbane. So my knowledge grows, both the servo rams and move on the brackets and seem only to "twitch" when trying to get reverse. that is the first repair i shall do when time permits next week. I would think if they are by-passing it would fail to travel forwards as well as backwards. it moves forwards , however seems slightly slower than it used to be, but that could just be me. ' Any clue to how far these rams should travel? Let me just go and measure how much shaft is exposed in the standing position. Right 35mm from the seal to the start of the flats on the shaft. That tells me these cylinders move about 18mm in either direction. I have easy 10mm movement in the mountings so over 50% of the actual movement is lost in slop alone. So i think this should be fixed as Step one. Mike [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
Kubota/Wacker Neuson/Hesston/IH/Ford/Other
A hello and quick into.. and a question..
Top