753 won't start

Skidsteer Forum - Bobcat, New Holland, Case, John Deere

Help Support Skidsteer:

hollowleg

Member
Joined
May 8, 2009
Messages
8
I just replaced the starter after it stayed engaged. I was told I should replace my ignition switch as it was believed to be the cause. So have done that and now all I get is the click of the fuel solenoid on the first notch of the key and nothing when the starter should kick in
 
Find a helper to operate your key while you probe the selinoid with a voltmeter to see if your getting power to the selinoid in the start mode.
 
Thanks fellas, I'll get my wife holding the key while I check the solinoid voltage. What and where is a starter relay located?
if your starter stays engaged and takes a ride with the motor than I always change the key switch , and relay along with the starter , the relay should be on a bracket on top the battery along with 4 others ones , the bracket has a decal on it to show which each one is for , check your fuses and recheck your wiring as you may have put the wrong wire in the wrong spot
 
Thanks fellas, I'll get my wife holding the key while I check the solinoid voltage. What and where is a starter relay located?
The solinoid is on the starter motor. Somewhere depending on year model there will also be a relay. G series it is between your legs below the seat, C and F series had them in the engine compartment beside the fuses.
Ken
 
The solinoid is on the starter motor. Somewhere depending on year model there will also be a relay. G series it is between your legs below the seat, C and F series had them in the engine compartment beside the fuses.
Ken
There are 2 relays above the battery. I switched them and the machine fired up right away, so will buy 2 new ones on Monday. Thanks for all your help, fellas. My headache disappeared with the sound of that motor. Once again, thank-you. Have a good weekend.
 

Latest posts

Back
Top