753 check hydraulic sensors values

[KyMadMan]

Does anyone know what the ohm values for these two sensors are? I believe one is temp and one is pressure. I have found most sensor values but these two elude me. Still getting a goofy code on the readout and I don't believe it is a display issue as everything lights up when the key is first turned on. Starting to wonder if that is suppose to be a ground fault code of some kind? Just trying to avoid a $1000 Bobcat bill. Thanks in advance.

Serial 508613###

 

[fortworth-cowboy]

Does anyone know what the ohm values for these two sensors are? I believe one is temp and one is pressure. I have found most sensor values but these two elude me. Still getting a goofy code on the readout and I don't believe it is a display issue as everything lights up when the key is first turned on. Starting to wonder if that is suppose to be a ground fault code of some kind? Just trying to avoid a $1000 Bobcat bill. Thanks in advance.

Serial #? Did you replaced the bulbs behind the display already?

 

[KyMadMan]

Serial #? Did you replaced the bulbs behind the display already?

Serial is 508613###
There only 1 single bulb in this display. When key is first turned on everything lights up on the display as it should. So I don't believe the issue is the display, more of a sensor out of range or not working at all. Could also be the Aux Hyd control module, but since hand control switches have not been connected for almost as long as I've owned it I don't think that is my issue. This one has been a head scratcher for sure. Thnx for responding FCB!