743b no start after fuel fill and bleeder replacement

[1702]

Ok so I have a 743b always a hard starter but been using it on this one job all summer. Took a lot of cranking to start but it would start. So the fuel bleeder which had the wheel busted off vibrated out and pissed fuel everywhere

Ordered a bleeder installed it , put new fuel in it and it wouldn't start since. I get fuel at the bleeder but I don't get any fuel at the injection lines .
To further muddy the waters earlier in the year the fuel shut off valve wasn't holding back I changed the solenoid still didn't hold back so I've been running it w a stick jammed on there to hold it open. It's been working fine this way all summer. So while o don't think that's the actual problem it may be some how contributing so figured I'd add that info
I've got about 3 days work left on this job all skid steer work.
Any help appreciated to get this old girl up and running .

This winter I'll do a V2203 swap

 

[1702]

anybody got an idea why Im
Not getting fuel past the injection pump to the fuel lines at the injectors? Have cycled the fuel shut off and held it back still no fuel at the lines. But I have fuel flowing at the bleeder valve. Ball is pumped up hard

If it was the inexpensive fuel pump wouldn't the ball still pump fuel
To the lines of the injection pump was working?