Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
632
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="jerry" data-source="post: 11009" data-attributes="member: 931"><p>The point gap on the ford engine is.025, initial timing with vacuum advance disconnected is 12 degrees btc, dwell angle with advance connected is 48 to 52 degrees. The two valves are indeed the hyd oil level checks. I am not sure what you need off the dist for numbers. If I recall there is a thread on this site about these engines and they were used in ford fiestas a long time ago. really is no big deal to pull the distributor out and replace if you make reference marks on it so you put it back the same way.</p></blockquote><p></p>
[QUOTE="jerry, post: 11009, member: 931"] The point gap on the ford engine is.025, initial timing with vacuum advance disconnected is 12 degrees btc, dwell angle with advance connected is 48 to 52 degrees. The two valves are indeed the hyd oil level checks. I am not sure what you need off the dist for numbers. If I recall there is a thread on this site about these engines and they were used in ford fiestas a long time ago. really is no big deal to pull the distributor out and replace if you make reference marks on it so you put it back the same way. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
632
Top