Reply to thread

Message: <blockquote data-quote="Fishfiles" data-source="post: 37474" data-attributes="member: 782"><p>I would start by removing the belly pan as it is only 4 bolts and 2 of them should be slotted , if they are not slotted it will make it easier to put back if you cut a slot in the holes , could be one of the travel motor or dozer hoses , a oring on a fitting , the swivel ( rotary manifold ) seals , could be leaking from above the turn table into the belly , but the worst case senerio would be thats it's leaking from the swing output shaft seal</p></blockquote><p></p>