Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
Caterpillar Skidsteer Forum
246 Engine Oil Pressure Light Not Working
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="CrashWrench150" data-source="post: 88635" data-attributes="member: 10342"><p>Hi to All, Currently I have In the Shop a " 246C Diesel powered 4 cylinder Wheeled Kiittyy When go to start, First , Key Position "ON" ( Not Start yet ) All the Lights are "ON / Self Test " -- This is OK , ( a Few Seconds pass ) All the Lights go Out , Except the " Park Brake and the Hydraulic Lock - Light ( This Is OK ) There Is No "" No ,,, Oil Pressure Warning LIGHT !!!!""" I have no Trouble / Falt Codes , Everything else Works Properly . The engine has good oil pressure ( Installed a Mechcanical test Gauge to check )... The " Oil Pressure Switch is good , The Engine Wire Harnesss Is Good ( From engine To ECM ) , the cab wire harness Is Good ( From ECM to Left Monitor Panel ) IF I have the key -on And jumper wire the Oil pressure switch wire To battery Ground ( Still No- Light ! ) Now , START Engine ,, Ground the oill pressure switch Wire to the Frame ( Or Anywhere , Battery ) Wait 20- 30 Seconds , the warning light and that Oil Pressure COMES On !!!!!! This dose not Seem RIGHT, All The Other Skid-s Work fine ..... Any ideas ??? Thanks , Later, Mark K. High Point , N.C. USA</p></blockquote><p></p>
[QUOTE="CrashWrench150, post: 88635, member: 10342"] Hi to All, Currently I have In the Shop a " 246C Diesel powered 4 cylinder Wheeled Kiittyy When go to start, First , Key Position "ON" ( Not Start yet ) All the Lights are "ON / Self Test " -- This is OK , ( a Few Seconds pass ) All the Lights go Out , Except the " Park Brake and the Hydraulic Lock - Light ( This Is OK ) There Is No "" No ,,, Oil Pressure Warning LIGHT !!!!""" I have no Trouble / Falt Codes , Everything else Works Properly . The engine has good oil pressure ( Installed a Mechcanical test Gauge to check )... The " Oil Pressure Switch is good , The Engine Wire Harnesss Is Good ( From engine To ECM ) , the cab wire harness Is Good ( From ECM to Left Monitor Panel ) IF I have the key -on And jumper wire the Oil pressure switch wire To battery Ground ( Still No- Light ! ) Now , START Engine ,, Ground the oill pressure switch Wire to the Frame ( Or Anywhere , Battery ) Wait 20- 30 Seconds , the warning light and that Oil Pressure COMES On !!!!!! This dose not Seem RIGHT, All The Other Skid-s Work fine ..... Any ideas ??? Thanks , Later, Mark K. High Point , N.C. USA [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
Caterpillar Skidsteer Forum
246 Engine Oil Pressure Light Not Working
Top