Reply to thread

Message: <blockquote data-quote="Mike10" data-source="post: 46131" data-attributes="member: 5461">There are two wire connectors on the back of the panel.  The inner one should be the one you need to check.The only thing you can check is if you have power and ground to the panel.  Without being in the seat and the key off you should have power at pin 14, it is  R/LTGN and should be the last pin in that connector.  Pin 13 is ground.Now sit in the seat with the key off.  You should now have power at pin 4 it is T/W.  Fasten your seat belt and then you should have power at pin 11 it is LT/GN.There are other pins that power up when you start but since the lights do not go out this should be sufficient.  With the seat belt fastend and sitting in the seat you should have power at these three pins and the ground should maintain the ground.You can have the panel repaired at AG-Express in Sulphur Springs, IN.  You can look them up on the net.  If possible I would try another panel just to make sure the problem is in the panel but the light problem is definitly not right.</blockquote>