Recent content by Yetiman

Figured I should update the community and if Nothing else the thread incase anybody comes across it in the future and needs the reference. Keep in mind my machine is a 1981 apparently. I ended up getting the large nut off the end of the drive sprocket by using a plumbers wrench with a 4 foot...

So I disassembled the motor via the back side, and low and behold i found what the dealer service manual calls the drive shaft sheared in half. I uploaded a picture via the previous link. I still need to remove the nut at the end to get at the other half of the drive shaft... guess i will strap...

So stupid question. How do I get the sprocket off? Lock the sprocket down and a big wrench on the nut at the end? Normal left hand thread? If that’s the case I will give it a go, just don’t want to wreak it any worse than it already is.

Ya I plan on pulling it apart. Just trying to figure out which seal kit to get. There appears to be one for a tapered shaft with key, and one with splines. Since I had to take apart the chaincase to take the chains off the sprockets to me that would indicate that this is the tapered shaft...

Well got the motor out after disconnecting the front and rear chains. Kinda a nightmare. So do I try a seal kit or find a rebuilt one?

Small update. I flipped the 4 hydraulic hoses off of the pump, believing that I switched sides of the pump. I can now control the right motor with the left stick but the left motor remains dead. Guess this points to the motor, correct? Any place that I can get a rebuilt motor from with warranty...

Hey everybody. So everything was going great after I took care of my leaking Auxiliary hydraulic couplers, and was leveling out a spot in the backyard for a pool yesterday for about 2 hours. Today as soon as I pushed into the soil I basically lost all drive power on the left stick. I can still...

Thanks for the reply. I took the joints apart and found the O ring in a pretty sad state so I will replace that. And like you said it didn't bleed out too much oil, nor was it under a high amount of pressure. Thanks for the help!

Morning. New to the community and new owner of a very used Bobcat 632. Purchased mainly for some work around the yard. Anyways I have found that I have developed a small leak when running the engine at high RPM on what I believe to be the high pressure side of the auxiliary hydraulics. I think...