Recent content by Xoloski

What is the part number of the $55 part you ordered to correct your brake switch issue on your Ghel 2054?

My Mustang 2054 wasn't starting. The starter solenoind wouldn't engauge with the key, but it started with a momentary jumper between the starter battery cable and the starter solenoid. I discovered the neutral switch wire disconnected and repaired the terminal. Now, the ingition switch engauges...

I agree, Golden Eagle is great to buy from. My closest dealer is Earhart in Tucson, there folks are so rude I'd rather wait 2 days to recieve a part (and save 15%) by using Golden Eagle.

I have a Mustang 2054, good engine, good hydraulics. The electrical system is very unreliable. The controls are excessively complex, my control cable rod ends failed at 600 hours. If I had it to do over, I think I would stay away from Mustang and lean toward Bobcat.

On the Discount Tire stores website, you can input the wheel / hub dimensions and it will give you a listing of available wheels, if any exist. You can also input the vehicle (car/truck) information and cross reference the wheels.

Mine is inside the engine compartment, on the left hand side. There is a tank with a cap. Inside the cap is a dipstick to measure the level. Use good quality hydraulic fluid. good luck,

First My ebrakenot locked on my Mustang 2054. Then it would start and die within a few seconds. There were two blown fuses, now it runs but the ebrakenot still locks. I'll look in the manual for a wiring diagram, I've seen it before, not sure I can download the diagram for posting however. I...

OK..... opening the orang wire circuit does not work. the offending part is MUSTANG CONTROL MODULE: PART#: 420-35604. The cost is $218.48 at Earhart in Tucson, +8% tax or, 205.96 + shipping from Golden Eagle of Pennsylvania. I've bought from Golden Eagle before, good folks. I will save the...

my 2054 does the same thing, every so often it goes into lockout mode. It has always come out with time, fooling with the switches, or other things. I have not found a pattern for why it goes in or comes out of lockout. I did talk to the Tech at the Tucson shop. He said the problem is the...