Recent content by tyus4

I have had this machine for 6 years now with no problems at all. All I have done is rebuilt the hydraulic cylinders. Took her out for the first time this season and she is bogging down when I do multiple functions. As in, backing up while lowering bucket. She is a 1978 so I know she is old and...

So I pulled the seat and seat panel out and followed the duct and found the heater. It is a aftermarket kit. I followed the power wire and noticed it was run through all the grunge, dirt, and oil on the bottom of the machine with 3 butt connectors through out it. So figured it was probably...

Thanks for the response. I will give it a shot

The air comes out of between your legs between the 2 joy sticks...it has a panel there that I removed that has the heater duct attached to it. the duct takes a sharp turn and can't really see too much thats why I was thinkin about removing seat and bottom panel. Thanks

I'm not sure to tell you the truth. I was hoping to find a diagram to figure out where exactly the heater is located so I can diagnose better. I haven't been able to dig into it much but I think I might have to remove the seat and panel underneath to get access to front of engine, where I'm...

Just wondering if anyone can help me out. When I flip the switch for the heater it blows the main fuse on the machine. Sometimes it will run for a couple seconds and blow and others it blows instantly. I have the parts manual and have gone through the whole thing looking at the digrams and...

Thanks for the info. I will give them a try. Machine is a 1978. I didn't think they would still carry parts for such a old machine

Anyone know where I can find a wiper arm and blade for a 632? I tested the motor and it seems to be working fine. Just need everything else. Thanks

Well I came to realize that my machine is just too small and too old for the stumps I have. I got about a 6 inch stump out then tried the next size up that I had and work at it for over 2 hours with no luck. The rest of the stumps are bigger so its for sale already.

I just went to the local tractor supply co. and they had the pioneer ones so I just put them on the bucket. Going to try it now. Hope it all works

Also, is Safeway/Pioneer Interchange Coupler the right thing im looking for? So then I just have to figure out the npt size?

If I was to replace the fittings on the machine with flat faced ones, fluid would go everywhere right? Also, what do you reccomend for fluid for this machine? THanks

So I picked up a stump bucket with grapple today and I can not get the fittings to fit. The fittings on my machine say 7/8 14 ...while the fittings on the bucket say Stucci-M-Firg 12A Npt -G11 and 12AD Npt - F-11 ...Do I need to get new fittings or am I just connecting them wrong? If its new...

I'm finally going to purchase a stump bucket with grapple. I've never used the hydraulics on my machine before. So I don't know if they work. I know you move the right lever right and left to use the hydraulics. Basically wondering if they dont' work, is it expensive fix? I just don't want to...

Has anyone ordered one online before with out paying huge shipping costs???? If so, where did you order from? I can't seem to find a local place that carries them.