Recent content by TimberBen

Great thanks for the formula.

I figured it out. Eaton pump part number 26016-RAJ. The specs are on the web

Called my dealer, check coil and solenoid for BICS control valve. Coil part number is 6671025 should have red and black wire. We had to destroy my solenoid to remove the coil it was a pain to remove easy to get to tho. They mentioned the lock spool solenoid???

Have your alternator checked. My machine ran fine but the horn and backup alarm wouldn’t work. After growing grey hairs checking wires it turned out to be a bad alternator.

My t200 would randomly lock the brakes. I can’t remember exactly what was fixed (I’ve been asleep a time or two since then) but I think it was a solenoid for the park brake. Does the light on the switch come on when it acts up? I can contact my dealer who fixed mine if you need.

If it helps the numbers I’m looking for are stamped or etched in the side of the pump body. I know from the mt85 specs that the pump should be about 10 to 12 gallons per minute at 3700rpm. But those are bobcat specs I want the pump specs. I want to be able to stock one pump that will work for...

I would like to know the Eaton / danfoss part number for the hydraulic pump. I have the bobcat part number. I need the specs for the pump itself. I am building a log delimber and using my spare mt85 kubota engine. I would like to use the same pump for both but need the specs to make sure the...

Ammonia keeps the bears from chewing things up.

Don’t go to short. The hoses will curl up under the attachment plate. I recently put new hoses on my bobcat 15 auger and I made them to short. I use my auger on a t200 and mt85, also I rent the auger to a friend who converted a Deere tractor to Skid-steer attachment plate. The hoses are just...

I have put 2” square receiver hitch’s on both my grapple buckets my mower deck and built a dedicated receiver with a bare attachment plate I got from an auction and also have put a ball on the tip of the forklift fork. The dedicated hitch is the best. It moves the ball closer to the machine...

Just a thought but alternator? I have a t200. My horn and backup alarm didn’t work for a long time. Pulled many hairs out trying to diagnose. Had my alternator checked and it was bad. Put in Napa alternator and it fixed it.

I am workin on a 325 that I just pick up. I am replacing the ignition switch so I removed the gauges. With the gauge panel removed none of my functions worked. When I put the gauge panel back in I got the functions back. Mine is the older style 325 with the square gauge panel. It is just a...

Well after doing some research I prolly do have a seal out and most likely a bearing going. My local hydraulic shop seems to think they can rebuild it. I hope they can and when they do I'll know more about what went south in the thing.

Thanks farmshop. I check the drain filter when I do my services, it's part of the program. Filter was clean as a whistle. I also talked to my dealer service guy today and he hadn't seen this problem before but had a lot of good input. Prolly looking at a rebuilt final swap once mine goes fully...

02 t200 3700hrs. I did a service on the machine and when I drained the hub oil the right side just kept draining out. A lot more oil than normal, never quit draining. I change my filters and oils about every 200 hrs and haven't had this problem, always clean normal amount of oil in the hub. I...