Recent content by TigerWebb30

Help Support SkidSteer Forum:

  1. T

    430 - Shut Off and Won't Start Back

    I finally got my 430 to crank back up. I'm still not sure what happened but bleeding the fuel lines again got me going. I opened the bleeding screw on the fuel filter and then the two on the pump and once I got a good stream of fuel and tightened them back up, the machine cranked right up. I had...
  2. T

    430 - Shut Off and Won't Start Back

    Fishfiles -- I did take out the seat and the only solenoid I could find is one that is mounted to the outside of the injector pump, or the gear casing that runs the injector pump. I can't really tell for sure if they are two seperate units or if it is all made together. But you can't see...
  3. T

    430 - Shut Off and Won't Start Back

    I have removed the inspection plate on top of the injector pump to inspect the fuel shutoff solenoid. It appears to be operating correctly. As soon as the engine begins cranking the solenoid activates and pulls the plunger and as soon as I turn the key off the solenoid pushes the plunger back...
  4. T

    430 - Shut Off and Won't Start Back

    It is a Kubota engine. I will check the fuel shutoff this evening.
  5. T

    430 - Shut Off and Won't Start Back

    I have a 430 that I was running yesterday and the engine just suddenly shut down. Now it will not start back. The machine only has about 700 hours on it and has run trouble free until now. It does not give any error codes except a 22-02 when I crank it for a couple of seconds and it fails to...
  6. T

    430 Hydraulics are Weak

    I'm just holding enough pressure to not drop whatever it is that I'm swinging with, but if you mean constantly holding the thumb control, then no I am not constantly holding the thumb control while trying to swing. Sometimes the machine won't swing at all if I am trying to swing uphill on an...
  7. T

    430 Hydraulics are Weak

    If weak hydraulics is an inherent problem with the machine, is there anything that can be done to make them better? My guess would be NO, but I don't know a lot about these machines.
  8. T

    430 Hydraulics are Weak

    I have a 2006 430 that the hydraulics seem to be a little weak on. It does pretty good when digging but when you lift something with the thumb and try to pivot, sometimes it doesn't have enough power to pivot the machine. This is especially true if you are on any kind of a slope. Is this normal...
Top