Recent content by thatdamnabe

I have already replaced the port block filter. And yes I have enough power to back the machine out of my , but not enough to turn. The guy I mentioned above said the spring he was talking about was colored, and different colors signified different pressures?

I spoke to a man who told me that on the top of my pumps on the very center is a plug, he told me that under this plug there should be a spring and a popett. I removed my plug abc nothing was beneath it. I have very little power to my wheels, he seems to think that this pretty isn't allowing...

No water. Tiny Air bubbles machine has New oil

Looked in my hydraulic tank and found it looked milky white. Upon further inspection i noticed it is air bubbles. Started with the port block filter and found what appears to be a screwdriver hole punched through the back of it. Had to order a new filter should be in in a few days. Bobcat...

Please!!

Have a 1978 632. Rear pump housing was cracked and i replaced it. So when this happened the oil from the back case drained out. Put it back together filled the hydraulic oil tank and started the engine. I then bled the pump from the top bleeder bolt and cycled it back to the tank. Put the...

I finally got my izuzu 2.2 di termo king diesel into my 632 bobcat. Now I dont know how to wire it. I bought the machine and the Rops wires are cut as well are the ones on the engine. I dont imagine I need much to run it. I am confused looking at the starter wiring. cant find diagram? I am also...

Repairing a broken 632. U joint was detached from the plate that attaches to the aftermarket izuzu di 2.2. The problem is that this plate looks machined and is not savable unless I drilled out the threaded holes on this aluminum plate and replaced the bolts with a bolt and nut. There is enough...

Ok so got it home pulled the 2.2 Perkins. Pulled the engine found a mess. Need to see if I can find the number one pump housing. As the u joint failed it twisted the pump and broke the cast iron housing where my pump bracket mounts to the pump. Any ideas on a pump housing part number? I figure...

Gas engine has been replaced to diesel only paying $800 for the machine with a brand new set of unmounted tires. figured worst case I could part it out or scrap it to retain my money. I'm mechanically inclined and am in desperate need of a project and a bobcat, figured this will kill 2 birds...

Shook hands. But the bracket I can fabricate I'm just concerned about what in the world would cause out to break in the first place. The guy said frozen u joint. But I figured that would cause a vibration not a break. If it even has that type of connection.

I just purchased my first bobcat. Its a '78 632. The guy I bought it from said he was abusing it and got a thump under the seat and shut it down. Upon getting a closer look I see that the brackets on the pump are broken, both front and back on the left side looking into the cage. I am wondering...