Recent content by tfkareus

Initially when I had it topped off, it was coming out the hydraulic tank fill cap. Its not coming out anymore. Now I can see oil in the bottom half of the sight glass and foam on the top half of the sight glass after I run for a little while. Other than seeing it present their, I don't even...

No hesitation what so ever. Everything is very responsive.

before it cause's a problem with the pump.

Hello, Got another project I want to fix because it cause's a problem with the pump. I am getting quite a bit of foam in my hydraulic tank. I don't have any leaks anywhere on the system so I'm wondering where the air is coming from. Any suggestions on where to start. My first guess is a cracked...

Ended up being the fuel pick up tube that goes inside the tank. Just pulled the elbow out with the grommet and replaced it. Runs good now. Boy was it ever hard to get that grommet pushed back down into the tank (no leverage to push).

Nope, not the fuel cap. Onto replacing the fuel supply line.

Thank you! With a good light I was able to see the two hoses (supply and overfill) thru the side panel. I can reach in there and feel my way ... wish me luck! Would it be worth rerouting the line around the side of the engine rather than under. My lines seem pretty tight going under ... might be...

Hello, I'm having a fuel delivery problem with my 2003 T300. Runs fine from a supply line from a 5-gallon fill can to the primer bulb and up. When I connect back to the tank supply line (1/4" ID). It may run on low idle w/ no load. But when I try to do something with it, it will slow and cut...