Recent content by teck6

8 volt control system , 5 volt computor referance .. MUST have 8 volts .. Controller should be where dealer said , may be farther down or under right panel area. A good dealer with correct software should be able to check these parameters. Hope this helps ..

Diagnose codes in order of appearance .. If actuator code comes up first adress that code first.. Dealer should install actuator has to be calibrated to get max life from it.. If u purchase and install yourself it may get u going but life of new actuator may be reduced... If your sensor supply...

If 743 has big bolt in middle of axle (removable hub) should be a B series...

Find a local Bobcat dealer.. Service manauals should be avail in paper or on DVD...

(337/341 Torque Limiter Adjustment Rexroth has designed a new torque limiter that will be a drop in replacement of the current torque limiter. It addresses customer complaint of engine bogging and erratic pump operation. See SL#5217 (EXR99) for affected range and instructions. Updated margin...

Check with your dealer ,at one time there was a new torque limiter from Rexroth.. Check bobcat service letter # 5217... This may be an issue depending on ser# of your unit.

Take a look at www.skidsteerstuff.com he may have what u need...

Thanks ,thats great info.. Ordered from my bearing supply...

Does anyone know where we can get axle seal repair kits for 463 bobcat? Bobcat parts tells me not available but unit has them installed now and we need replacements.. Some people may call them speedy sleves.. Part number or vendor info would be great.. Thanks..

Check your fuel quality,i have seen units stall have poor power with a certain amount of gas in diesel fuel.

http://www.skidsteerstuff.com/skidsteer_cab_heater.htm Take a look at his stuff,have not used it but it helped me do my 773G.

Does unit give u a service code? press and hold headlight button to get codes.. Possible alternator not charging.