Recent content by T-bar

G'day again from Western Australia. I am welding out and remachining some flogged out bucket pins (and replacing bushes) on my '96 940E, and would like clarification on pin diameter. Measuring with a micrometer in the least worn area seems to show a maximum diameter of 31.51 mm. Would I be safe...

Ah, OK, so I've found the parts manual now, it's a shock absorber that's missing, not a spring !

Thank you. I got stuck into it yesterday, and yep, got her sorted out a bit. It was mostly adjustment, but there is a flogged out Heim joint, and someone had used a 5/16" bolt where there should have been a 3/8", so even more play. I've got it so it doesn't creep any more, so that's a good...

Thanks. What adjustment needs to be made to set it into neutral ?

Hi guys. I've just bought a 96 (I think) Mustang 940E, and have a couple of issues I need to address. Firstly, is it possible to obtain Operators, and Service/Maintenance manuals for this machine ? Where would I start looking for them ? Also, the machine creeps forward quite badly as soon as the...

Hi fellas, I'm new to the forum, and Mustangs, and this thread was of particular interest, as my 940E creeps forward (well, more than creeps, to be honest) unless the T-bar stick is pulled back slightly. Is this likely to be caused by the neutral spring you're talking about ? Where is this...