I actually got it working somewhat today. turns out the connections on the control module were corroded. every thing now is working except the over ride
working on an early 773 f series. I'm not getting juice to the brake solenoid. and the traction light is flashing slow and steadily. When i jump the relay the selenoid does engauge. does any one have a wiring diagram for the older 773 without boss system?
I just happen to own a machine shop so I think I'm just going to buy some chrome shaft material and just make longer rods and put them into the existing housings, I really only need 1 inch to close them.
I bought a door that was supposed to fit a 763 but it doesn't. it's too wide to fit between the grab rails. but figured i would buy a glass for it and resell it. well, i went through all 7,8, and 9 series and they all have the wiper at the bottom. this one is on top. Any one have an idea what it...
I just bought 5, 72-inch OEM bobcat grapple buckets. all used. When i finally got them home and tried them out I notice all 5 don't close all the way. the tines stop about 3 inches above the cutting edge. Is this normal or are all 5 bent the same somehow?
trying to put new bearings and seals in the fan gearbox on a 763. i got the part that holds the fan apart but i cant figure out how to get the other half apart, the part with the pully. does anyone have a picture of the inside or know how the shaft comes out? i took the bolt out if the bottom...