Recent content by SomeoneSpecial88

Finally figured it out, ended up taking off the cage on one side to make things easier to access then I removed the seat belt anchor, as well a two other bolts, then removed 3 bolts on the deck behind the drivers seat on the outer edge this is the deck above the air cleaner. From the back of the...

So I have a quick question I'm trying to get my valve cover off and originally I couldn't get it over the studs when I would tip it at an angle the studs stuck up too far or so I thought so I took the studs out using the jam nut method but I still can't clear the sloped piece of metal that is...

I'll check back for update and to give some when I start working on my fuel pump thanks again and good luck.

Thank you soo much for your quick and thorough response. It will help a lot since I also have the Case 1835b with the 188D. I truly appreciate you taking the time to give such detailed information. It's very encouraging since I'm a bit nervous about taking it on but it can't really end up much...

Hey, I know nobody responded yet I'm early and I don't have the answer since I'm dealing with pretty much the same situation. I was wondering if you could help me though lol I need to rebuild my fuel injection pump because of the flex ring failure (at least I'm fairly certain that is what the...

It is a diesel, and there is no power at the instrument panel with the key on. There is no lights, sounds etc. It's just dead. We verified with a multimeter not power at the switch.

I do have the service manual, but I'll have to see if I can find the parts manual since it sounds like that would be beneficial for those situations, Thanks! On another note now that I rebuilt the tilt cylinders it started twice we used it no leaks so that's a plus, parked it to top off the...

Update: After fixing the broken chain, it seems to be a little bit better, I do however need to check/adjust the other side. I haven't gotten there yet due to the fact that my bucket tilt cylinders started leaking like sieves so I'm currently rebuilding the cylinders. Will update again if I...

Thank you all for the suggestions and replies. I'm going to try some of these things as soon as I get some free time and I'll make an update with my findings. Really appreciate all the input.

Well, last night I was able to successfully get the chain replaced on the skid steer and got the deflection adjusted. Thanks for input and suggestions and yes the chain breaker tool was well worth it. I'm still having the issue with the skid steer not making tight turns. It just feels like the...

Thank you so much for all your help, hopefully I'll have some time tomorrow afternoon to look at it better/work on it.

The book Well to confirm what the book says it should have and what is in it ,fish out the old chain and compare it to what the book says 60 h sounds right.h Thanks, the book doesn't say I went through it multiple times and there is no information or spec for the chain just the procedure for...

Hey all I'm brand new to the forum and also to skid steers in general so I'd like to preface this by saying although I'm mechanically Inclined to an extent I have zero experience with working on skid steers or heavy equipment, I've rebuilt the hydrostatic transmission in my JD lawn mower and...

Hey all I'm new to the forum I have a case 1835b Diesel and all the problems that come with it lol

Hey all I'm brand new to the forum and also to skid steers in general so I'd like to preface this by saying although I'm mechanically Inclined to an extent I have zero experience with working on skid steers or heavy equipment, I've rebuilt the hydrostatic transmission in my JD lawn mower and...