Recent content by Skidster

Hello all ! I have problem with my e19 2005 excavator. Swing function not work at idle rpm. Swing will work while any other hydraulic function is activated. But when other hydraulic function is deactivated, swing will stop after few seconds. We have done hydraulic pressure test for main relief...

Hello, i have problem with my s650 2015year model. D24nap doosan engine. There was 3 fault codes. Fuel temp sensor + IMV faults was connector problems. I have left only 1 fault code m2899 for secondary throttle sensor calibration required. I think this fault isnt the problem for starting engine...

Hey everyone! I have problem with 2015 s100. It working well with throttle on. But when throttle is at idle postition(1000-1100 RPM), it will bogs down and shut off when i try to turn over or turn on aux hydraulics. If RPM are over 1500 it works well. I haven’t experianced this any other skid...

Hello everyone, im new member here ! I’ve been working on my 2019 S650 to start it up. It only has 250 working hours and it’s wont fire up. Its working fine since one morning i reached to bobcat and saw error code (M7748: Key switch multiple) on instrument panel and wont able to start engine...