Recent content by Skid Kid56

I see no real answer was put up other than references. The TL10 has one large bolt on each side of the cab opening. Sitting in the operator seat the head of the bolts are visible in the front corners of the lower frame of the cab on the left and right. Remove one at a time and hold the cab down...

Here are screen shots and a short vid of the alarm.

The manual that I downloaded doesn't tell about the screen symbols so it is not helpful. It is mostly an operator manual and doesn't cover service operations. Thanks for the reply. The sender seems to be ok at this point of checking. The screen that shows some data of running vitals shows temp...

Thank you. Finally I get to run a skid and have fun with it. For years I just worked on them for others and business but didn't get to enjoy one. Good times.

I'm not an owner of this TL10V2 but I keep it going for my neighbor. I am certified, or certifiable - something like that, in equipment troubleshooting, repair and maintenance but I don't have any training with Takeuchi so I have to ask questions. I hope to contribute here and get good info as...

TL10V2 is erratic with this alarm that sounds. It may happen at start up and it may happen after some time of operation. It never seems to happen at a consistent time or a pattern but it will happen. The alarm goes off and the red symbol like crank case with the exclamation mark in it flashes in...