Recent content by Sharp Rents

Here's a picture of the timing marks on the pump gear and where it was when I pulled it. Know it turns a little on the way out and in. Noone mentioned the spacer behind the gear and I don't like forcing or prying on any engine part. Lol got it though. here's a pic of old one here is a pic...

Rod bearings? Oil pressure is fine and no contaminants in oil.

3&4 cyl low compression but not blown head gasket. Valves ok.

Thanks, I will pull the old one being careful not to rotate it and match where it is when I put the new one in. should be able to keep it within a notch or two. Will bring it up tdc. I have to rebuild this motor next winter so will get it right on when I do that. Trying not to have to pull the...

does the gear on the common rail injector pump have to be timed? I can't find any drawings that show if the gear drives any thing else that might need timed with it. I read an old tread and comments were yes then no. Not a Kabota. It is a Doosan 2.4 in a Bobcat T590 skid steer. tia