Recent content by Sawmillman

I want to make a post that would be seen by all skid steer owners no matter what brand. Not sure where the best spot is. It's about camera ideas for blind spots in tight quarters. The sides for going by things, rear & front to see over horizontal bar between the lift arms. Thanks!

Anyone here have a good way to set one of these up when not in use? It's a pain to get it down on block & safely set up, especially by myself. I set it on cynder block, 1 on each side of the quick attach & 1 in the center where the boom swivels. I have to get on & off to reposition all of them...

Mine are to the point where when I pulled up on the bottom of the chain & dropped it I can hear it tap the bottom of the chain case. There are wear marks/ scratches below each sprocket, but I think that is from a previous chain. ? I'm totally against a tight chain, I know it will wear out...

Hey ward, Thanks for the reply. I used to be an electrician and maintenance guy for a Tyco Electronics distribution facility. I had a lot of motors driving chain on miles of conveyor. I had to fix & maintain a lot of greasy chain. I didn't mind using spring clips or cotter pin master links...

It looks like the sprocket is marked Tsubaki & the chain has Japan on the link. I Googled Tsubaki 60SH & found some info from another manufacturer.

I have a 763 C series & my chain is Diamond 80, no other markings. I've read that it's supposed to be 80H, would that be indicated on the links if it was anything above a standard 80 chain? Bobcat online site only shows the chain, no size & 62 pitch, which I believe is the number of pitches or...

That is 60SH

I read in a post where a member mentioned looking in the manual thread. I searched & didn't see anything. I'd like to have access to a parts manual for my 763 C series skid loader. I just pulled all 4 axles & replaced all the bearings and seals. I wish I would have known that I had chain...

My fuel solenoid intermittently fails to engage. Sometimes it clicks on as soon as I turn the switch & other times I have to switch it off and on many times before it will engage. I've just started troubleshooting it. It has the older type solenoid timer seen in my attached image. I attached an...

Where you from? Stokes garage reminds me of Stokes County NC where I live.

I'm glad to find this forum, I've ran skid loaders for a long time, but just bought one for myself. I've ran all different makes, models & attachments. Mine is a 1995 Bobcat 763 "C series" Kubota V2203-E. It came with a 60" toothed bucket & a 709 Bobcat backhoe. Does the C series sound right to...