River Fluid Power's latest activity

Swap the entire control valves on the tandem pump. That’s the last thing you can try before pulling the whole pump out and looking...

I think that is either a Poclain or Rexroth. I can’t get those at this time. Can you verify the brand?

You could have a bad seal area on the shaft or a bad seal. Or both. The seal carriers bolted to the front of these motors crack...

You’re welcome.

The displacement of the 26016 pump is .72cid. You can multiply the displacement by the rpm you will run at and divide the result by 231...

@AJ-17 That seems steep! Do you have the model number for the motor? I can possibly get you a motor cheaper, and parts are possible as well.

The seal is most likely leaking due to internal wear and/or damage in the motor. A leaking seal by itself is not always a sign of a weak...

Not familiar with your machine but a blown seal could cause some loss of power. However, did the seal fail because of old age or is...

Possibly. If you lose hydraulics suddenly, it is usually the gear pump or the main relief valve in the hydraulic control valve.

It is possible that the gear pump failed. You can check it with a flow meter that has a pressure gauge and needle valve.