Recent content by Richard57

Yes, the top

Thanks, I'll give that a try tomorrow

I know it's not called a solid but this is the part with open wiring. Can't find information on adjustment

One of the things I was going to replace was the sender. Except Bobcat has them backordered until late July. 05-09 low charge pressure

One of the first things I did when I bought it last year was a new cap. It was filthy.

What about the adjustment on the solenoid for pump motors. Only because it seems to have started after I redid the wiring.

It seems to come on a lot faster at low idle, maybe 10 minutes.

Both hydrostatic pumps were pulled last year because of open wiring..Does not really track good, was wondering if my pump neutral need to be readjusted. Yes I calibrated it after putting back together.

Tension seems tight, I took off idle pulley to get it on

I changed the cartridge filter, the one that looks like an oil filter and changed out both drain case filters. Machine has 2400 hours on it. No metal shavings found.

Those are not the right pressure I apologize,,,me sitting in chair and notes are in the shop.I think it was 345&360psi

Ok so far I've replaced pump drive belt,rebuilt drain case heaters, changed 5 gallons of hyd. fluid. Put tee in line and checked pressure,145 at low idle and 160 at high idle, according to service manual is spot on. It did lower a little bit when warmed up. I do have sjc controls.

Doing good, thanks for asking. Now if I can figure out why I get code 05-09 when the machine warms up I'd be doing a whole lot better.