Recent content by Pedrosotelo

Help Support SkidSteer Forum:

  1. P

    LS185b antifreeze in oil

    Hello, I am in the process of replacing a Turbo on my 2005 new holland ls185b and noticed the oil was milky. Is is possible the oil filter & cooler assembly is bad? Thanks
  2. P

    LS 185.b hydraulic oil discovered in back

    So here is where the hose was disconnected and I assume this is where it all leaked. Hose number 13 was disconnected from the hydrostatic pump. it goes to the hydrostatic oil return collector #5. Let me know your thoughts
  3. Hydrostatic Pump - oil collector.PNG

    Hydrostatic Pump - oil collector.PNG

  4. 20220226_134440.jpg

    20220226_134440.jpg

  5. 20220226_133521.jpg

    20220226_133521.jpg

  6. P

    LS 185.b hydraulic oil discovered in back

    So I replaced the filter but I noticed a ton of oil on the bottom plate. More than before. I put in a 5 gallon pail and it dumped it all again. I looked around and found a hose on the left hand (if sitting in loader) disconnected. I feel this may be the culprit. I have attached pictures. It was...
  7. 20220226_134204.jpg

    20220226_134204.jpg

  8. P

    LS 185.b hydraulic oil discovered in back

    Hi foton, thanks for your response. I wonder if the filter was cracked because of the I tried tightening at below zero temps. I did order one and will replace today. I am hoping this will allow me to move the loader backwards/forwards so that i can bring it over to my heated garage.
  9. P

    LS 185.b hydraulic oil discovered in back

    Hello, I need some help I discovered hydraulic fluid in the back plate area. It appears to be a ton of oil and when I check the dipstick it is empty. I noticed this after I tried to start the machine and move. It looks like there was a drip by the filter And when I remove the filter the inner...
  10. P

    Older NH LS185.B - Dead battery - Raise arm??

    I just purchased a 2007 NH LS185.B and was told it needs a new battery. Where you successfull? How did you replace it? I read somewhere that you can come in through the top and remove the manifold. Four screws and a bracket screw. Thoughts???
Top