Recent content by mitsubishiparts

Its looking like I'm going to try and reweld that retainer nut on. Thanks for the advice on the angle grind for a solid weld.. If I cant get this right, what harm would it be to run a stock 1 1/8 rod on one side and a aftermarket 1.5" rod on the other?

Oh, I didn't replace the electrical under the cap because it looked to be in very new condition. It looks like the ram was welded prior to this accident and I was just looking for a newer one but I might just reweld it up and go.

Oh yeah, and while I'm doing the belt, I should do the jackshaft bearings, it seems to be a little rumbly when its just idleing. Thanks!!!!!!!

Oh, and drivebelt was $108 at bobcat of portland.

Here is a update, I've bought the carb kit from Napa ($35), cap and rotor (maybe $20), After replacing what I could in the carb and doing the cap/rotor it fired right up once it got fuel, They also had the exhaust manifold gaskets for $11 and it made it MUCH quieter. Now that its running quite...

Ever need to change out the exhaust manifold 0-rings? Looks like I have one blown out (loud/smokey) Hopefully the manifold unbolts easy.. I'm gonna spray some penetrating lube and let it sit for a day or so.

Oh, is there a website or recommended store to buy the parts for these from? I need a belt, exhaust manifold "rings" or gaskets, ignition tuneup parts, carburator parts (its not wanting to idle and adjusting the mixture screw makes basically no difference in how it runs) Any other suggestions I...

Ok, Well I put some super clean in the engine bay / belt area. I then pressure washed it all, I also put some belt dressing on it hoping to make it grab better. I didn't fix the leak yet but I will. The machine basically did the same thing BUT, when I put it in high gear and the belt is tighter...

I started it this morning and same deal, turns ok for about 1/3 of a turn maybe 60 degrees in a circle. Then, would only nudge itself back. I see the feed line to the clutch system, I think its working ok mainly because when I pulled the cover, the clutch still was kinda dripping or wet. My...

Is there any chance I can get your email? Mine is [email protected] if you would send me a email I'd love it, if not. Then please be so kind as to help a young rookie out with this awesome machine! I put about 4 gallons of fluid in it tonight but it was to dark to do anything with the...

Thats ok, My local bobcat dealership is closed on the weekend. I'll be in touch with them monday.

It looks like the clutches are up high, and out of the fluid. I may be mistaken I have no experience!

Oh, reason I ask about the low fluid is, that mine seems to be a few inches low compared to the "fill to here" mark. Also, it will turn for the first few seconds of being started if that helps (doesn't turn stong tho).

My clutches look newer (and were supposedly recently replaced), they seem to be in adjustment (3-4" of travel in the sticks). My question is, is there any chance that if the ATF is low in the housing of the cat, will that make the machine not turn? My bobcat will only turn when its just started...