Recent content by marco93l

I was wondering if there was anyone in Oklahoma that someone knew of that would pull the motor and hydraulic pump out. I would do this, but I just had to motor apart and installed a new one, only to use the machine 30 minutes before the pump seemed to start having problems. Took it straight to...

Well, I changed the filter and move it back outside on some gravel. I noticed that when I move the sticks (one forward and one back) that most of the time, only the side that I am moving forward will move forward. The opposite side that I am pulling back with the lever, isn't moving at all. It...

Case drain filter? Are you referring to the hydraulic or hydrostatic filter? If you are, I did replace them.

Update: I lifted the bobcat in the air and ran it for a few minutes. It seemed to run fine. I set it on the ground and it did make a big difference, but it still gets loud when it turns. It will turn but you really have to play with the controls to get to at time. What I don't understand just...

I'm not to sure. Bobcat is inside the shop so I don't want to push it against anything. I am replacing another hose tomorrow and will give it a try. I replaced the lift arm hoses and they are working fine. That why I was confused why I could still drive it forward and backwards but not be able...

Just had the motor replaced on a melroe bobcat 773. Drove it around for maybe 2-3 minutes, pulled in back into shop to clean it all up and replace parts and paint. I replaced the seat andhad a problem with the sensor but got it working. I raised the bucket and noticed a hose with a pin hole...

Thanks. I lifted it up and I did notice that one of them was loose and almost hanging. I am going to replace the alum pivit and a bushing. I hope this will help. Thanks greatly. It is most appreciated!

What could possibly cause a bobcat to suddenly start jerking, the only way to stop it is to stop moving the loader forward and start to move it slowly. I noticed it doing this a few times before the motor went south. The jerking was pretty violent.???? I have the motor out now and wasn't sure if...

Yes, I have all the brackets removed and lower bolts and the flywheel stuff to the case. It is still in there tight, so I know I missed something in there. I am going to see if I can find anything online real fast and download it so that I can look into it again this evening. Thanks

Getting a replacement engine for the bobcat. I have removed the flywheel and cover. Everything up front and accessories. Removed two bolts underneath but the engine is still tight. I can tell there is still a bolt or two somewhere holding it in place but I can't find anything. I have a 773 I...

What do you mean by DI? This stuff is all new to me. I was lucky to get the bobcat used from someone that took advantage. Lol. I guess that's what happens when you don't do your homework and make impulsive Buys. I put about 4 hours in the machine before it went south, so a lot of this termlogy...

I am in Oklahoma City, Oklahoma. More power is always better, but I really am looking for the most simple , no modifications, plug and play change out. Thanks!

Is there a preferred vendor or business that is better priced for a replacement motor on a bobcat 773? It is the Kobota 4 cyl diesel. Thanks Mine just went south, rod is bent and cylinder wall is scratched also. I know it is going to be expensive and way too much for bobcat to replace, so I...