Recent content by lmcl123

Possibly the fuel pickup tube in the fuel tank. I had this happen on both a 1997 753 and a 1995 763. They get old and brittle over time. The 753 pick up tube snapped completely off just inside the top of the tank, that was easy to figure out. The 763 cracked about halfway down the pickup tube...

FYI.. Hopefully this info will help someone out in the future. If you ever have to replace your control valves on the 610, I may have stumbled onto a inexpensive replacement on the "VEVOR.com" website. I found two control valves that look almost identical to the ones on my 1974 Bobcat 610...

I've used chains on my bobcats for over 20 years. I tried steel over the tire tracks for about 2 hours of those 20 years. Don't like the tracks for snow removal. when I get get turned a little sideways on an incline, I go for a sled ride. On really hard pack almost icy conditions I spin out a...

I have run the same set up as you on two different snow plows for 20 plus years on five different bobcats, and have not had any problems. If you think about it, that is basically the same thing that happens in a two port cylinder. One direction extends the cylinder by forcing fluid back into the...

Okay, I'll try this again. No on the control valve. That middle pedal on your machine is hooked up to a spool valve that controls the hydraulics. On the 610, there were two types of aux lines. On mine, there were two steel lines with caps at the back of the machine. I ran two 3/8" lines from...

Try this link, it was an ep3 code for a bobcat 753. Probably very similar if not the same https://www.justanswer.com/heavy-equipment/2kd4r-753-codes-ep-3-turns-won-t-start-once-puffs.html

Here's a picture from the manual, it says 11gpm. I would think that as long as a snow blowers rated less than that, it would work. Some of that 11 gallons per minute might be used in driving the skidsteer since one pump Powers both the systems

I had a 2000 773G turbo with AHC controls. The AHC controller computer went out. Local dealer replaced it. when I went to pick it up, it was doing the same thing when lifting and tilting (violently shaking the machine). They spent 2 months trouble shooting it ($$$$). At the same time I was...

Here's a couple PDFs from my service manual on the two diesel engines that were in the 610

Do you have an enclosed cab? I had the same problem with mine. I noticed my seat bar sensor was damaged. I replaced it and still had the same problem. I finally discovered that when my side window was open and pushed all the way back it would occasionally bump on the seat sensor and freeze the...