Recent content by Kerry773

No problem, I jacked it with block in rear and up it went. Had to jack it about 2 feet to get that sucker out. Thanks to all for your help......

Whew---Thanks for sure, I'm back on it in morning. kerry

Thanks for your reply Tazza, I have bottle jack under the bucket right now but, it lifts the whole front of the bobcat. Front tires are off the ground and lift arms have'nt moved. What gives? Thanks, kerry

Hi guys, I'm trying to have my lift arm cylinder on the right side rebuilt. Here's the problem, I can't remove the cylinder from the loader. My repair book says, with the arms down, cab raised, release cylinder pins from both ends, which i did. Remove both hydraulic lines from the cylinder body...

I could'nt find my leak either. Finally, tried looking with the lift up and bucket dipped. There she was, at the back of the loader, hoses on either side that supply fluid to lift and bucket were leaking. Only with lift up though.

OK, here goes. I installed the new pump today, still have'nt cranked my beast. I'm walking round and round making sure every hose is back in its proper place. Have to replace filter hose and filter. Then I'll crank. I was told by bobcat that I should let it idle only a few seconds then shut it...

Hello Yall, well after cleaning for several hours I got down to taking that pump off. I'll try to explain what I did... 1. Raise the cab. Remove [2] 3/4 nuts from front of cab and raise, allowing cab to rest on a latch that prevents it from falling back down. 2. Drain hydraulic fluid from...

OK guys, I'm in the process of cleaning up the beast. Lots of grease and dirt. Still looking for the serial number. I'm told i'll need the correct SN to order parts. After a good cleaning i'm gonna remove the pump and look inside. I'll let u know what i find. thanks, kerry

Thanks for your reply Fishfiles. Ok, I'm looking from the bucket and I see a smaller looking somewhat square looking housing attached to the left end of the big pump. This housing has a large diameter hose coming from the hydraulic tank that bolts to the back of the small pump. On the front of...

Oh My.... Thanks Tazza for your reply. Can u lead me to where pumps are sold? Would this be the main hydraulic pump or something else? thanks kerry

Hi, no the system did'nt run dry. The hose was replaced because it was leaking. No i did'nt check for debris in the new hose. thanks for your reply. kerry

Hi, I'm new to this forum and I think there are very knowledgeable folks here. My problem is that my bobcat 773 drives very good and strong but the bucket lift and tilt are very slow and weak. It started gradually after I replaced a hydraulic hose that controlls the right lift cylinder. It is...