Recent content by jokerace31

Ok guys I received the replacement Spline shaft! I was able to handle getting the old one out and new one in cleaned housing and air dried with compressed air and unit is back in machine. Now I am going to get new filters and try and figure out this oil situation! It calls for 10w40 with an HTO...

Yes it is yellow appears to be original! I will check and inspect the u joint shaft as well!

Yes it is all 3 manoals on a disk! I think I would have liked the actual manual better could not beat the price for all 3 though!

Ok Gearclash what I have found so far is while running the the L and R side drive pumps get warm hydro pump on front was cold I pulled the Hydro pump and the coupler came right with it and the tip of the spline shaft was in the coupler. I just ordered the spline shaft off Ebay! Now I am fairly...

Ok pulled the Hydro pump and found out the spline shaft sheared off! Not sure what caused it hydro pump turns by hand! Not sure what is involved with repairing it yet I will dig into service manual and see if it will tell me! Any and all info is greatly appreciated. Thanks

Ok Tazza I got it running the wheels do slowly turn but I was able to stop them with my hand! Ujoint shaft is turning and the Twin pumps? I believe they are called anyhow they are getting warm! Now the pump on the very front seemed to stay cool. I read your reply and glad I was unable to get...

Also I have the machine up on stands and when I was able to turn the engine over the wheels where turning as well not sure if that helps at all just wanted to add that.

Ok went yesterday and did not have much luck figuring out anything other than the fact I am now researching starting issues. Ignition was already shot so I ordered a new one but I think I got a bad ground somewhere I had my test light out checking some contacts and the light tip touched the...

First off thank you for reply! I will be going today to check everything on machine I have already tore it down for clear vision on almost everything. I am pretty sure the Case has same shaft the guy I purchased from said it could be the pump or spline shaft or valve stuck and in researching...

Hi guys I just picked up a Case 1835b that runs fine but all Hydraulics are dead. I also picked up the manuals for the machine they have great info on rebuilding everything but the trouble shooting not so helpful! I had the machine transported to a buddies house and we tore it down to dive in...