Recent content by jmmillerfzr

My hydraulic return on my M371 seems to have a loop and maybe a check valve? I should take a picture. The manual shows the suction from the tank to the filter and then to the pump and back to the tank. Mine seems to loop back to the suction tube? Wondering I can can go back to how the manual...

The only reason I used the electric clutch is because I found it on ebay cheaper then I could have just bought the pulley for. I really didn't expedt it to work, I just planed on using the pulleys and bypassing the clutch feature, weld or some other method. When It arrived it was brand new, so...

Thought I would post some information on the repower of my Bobcat M-371. Skid came with a very tired kohler k321 16 hp single cylinder engine. After some debate on to rebuild or repower I found a 25 hp twin cylinder kohler command for a pretty good price. Overall things went very good and I got...

I'll get some pictures off tomorrow. I'll have to find a gage before I try to adjust the pressure. Thanks for the information.

I'm guessing I will need to increase the relief valve pressure as the last time this machine was running my buddy said it would barely lift a 1/4 bucket of gravel. Where do you hook up the pressure gage? on one of the output lines? Thanks

"I had one of those that I bought, fixed up and resold. It was a good basic little loader. I think they run forever. the only major thing that ever really seem to get done to them is a engine transplant. Mine had been bored out and rebuilt. I repacked cylinders and cleaned out the rusty fuel...

I just completed repowering my 371 to a 25hp twin kohler and a ogura electric clutch. So far I'm pretty happy with it, but the clutches and drive train are pretty noisy. How do you check for the proper fluid level in this machine? Also the right drive lever is very tight with maybe one inch of...