Recent content by jessemead

Has anyone ever had a bobcat t770 lose foot and hand throttle? Will only idle. No codes. Did calibrate foot throttle. Replaced throttle control, didn't do anything.

Are there reman injectors for this machine? Do they need to a calibration at the dealer?

Got a 3000 hour machine with an injector code that pops up every couple machine hours. It is E000651-31, injector #1 fault. Should I be worried? Just roll with it? What are options for repair?

has anyone added air conditioning to a bobcat s185 with an already heated cab? anyone know the cost? can you do it yourself? dealer costs if have to go that way?

has onyone added high flow to a standard flow 763? is it fairly easy? anyone know of parts list? I would really like to add it because I do a lot of mowing with a six foot brush hog and a homemade 3pt pto adapter so i can use more power!

i replaced the two on the front of the two straps that run back to pump and they connect to round barrel that you grease connect ed to drive sticks

i tightened up the drive linkage and replaced two front rubber bushings and that fixed it. very easy fix very lucky

that definately sounds like what it is doing. how hard is it do remove travel motor? it is a 1997 ser 512227976

Not really a noise you can just feel it in the sticks. doesn't do it pushing into a dirt pile and letting wheels spin.

i have a 97 763. it drives just fine forward and reverse but when you stop going forward and quick go backward still moving straight the left side drive has a weird skip or studder. its like when you double clutch a car. grab release grab release real quick three to four times. very annoying...

i am looking at getting a case 1825. it does not have aux hyd but is an option. does anyone one know how hard it is to add the aux hyd.

do i have to lift the cab to check this out?

i have a 97 763. when the skid sits and idles the fan makes an annoying grumbling noise. has anyone heard of this and how do you fix this problem

i was thinking of building a stump grinder, single stage just a spinning wheel. the rest of the actions i would use skidsteer for them. i have a 97 763 15 gpm. does anyone have any suggestions on getting a wheel or which hyd motor to use?

if the needle moves isn't gauge good?