Recent content by jake75

Bobcat s185

Anyone have a motor carrier bearing go out, would this be enough to stop a motor? Is it possible to replace the bearings without pulling the whole motor carrier group? Any thoughts?

Brake is off, I read somewhere about control block ?? Could something in there berthed issue, or can anything come loose on pump?

Something is locked up? Not sure what?

Pulled the belts off, separated hydraulics from engine, got it to turn over with no load , once I put the belts back on right back to the same problem, grinding to a halt and movement in the left hand stick ,

Also no codes, went to try and adjust neutral doesn't have the harsh jerk at the end but still shuts down, sounds like teeth getting in motion hitting a spline then dead,

From the beginning , had some creep in the wheels, ran at high throttle got rid of creep, had work to do . Bobcat stopped dead after hitting some rock up a hill in middle of nowhere. Bobcat will crank and try to start , violently halts after a couple seconds, like hydraulic brake kicks in? And...