Recent content by JackinVT

Help Support SkidSteer Forum:

  1. J

    Reconnecting 334 Auxiliary Quick Disconnect Coupler

    Hello! So the quick disconnect coupler for my auxiliary hydraulic thumb became disconnected while moving an old log. I am unable to reconnect it. I went through the motions to relieve the pressure on the excavator (334). The thumb cylinder is completely extended, the retract side is the one that...
  2. J

    Bobcat 334 Starting Issue

    Thanks for the help Tazza! The fuel filter was replaced just last summer, of course I guess it could still be plugged. Although once running, I did finally get it started, it remains running fine. The cracked pickup tube certainly sounds like a good idea. When just pumping the primer bulb I do...
  3. J

    Bobcat 334 Starting Issue

    Hello, My Bobcat 334 has been starting roughly recently. It starts immediately then coughs, sputters and stalls. After a few attempts at re-starting it finally coughs, sputters and continues to run fine. Today of course it never started. It appears to be a fuel issue, like some air in the line...
  4. J

    Leaking 334 Travel Motor Relief Valve Assembly

    Hello, I'm new here as I'm looking for help/advice. Last summer one of my travel motor relief valves started leaking around the top plug. Not having a new o-ring available I put some Teflon tape on it and that stopped the leak, temporarily. This summer now leaking again I attempted to remove the...
Top