Recent content by jack rabbit

Ihave a bobcat model 2560 around 1994 year i was using it on bobcat 743 uses hyd oil can I change hose ends and clean out hyd fluid put it on t300 bobcat

Thanks again Mike 10 put on new hydrostat charge Pressure sending unit runs fine now

Mike 10 - Thanks for the help. This is the 2nd time you have answered one of my posts. I Will check the sending unit this morning. Thanks again.

Put new hydraulic pump on. Washed out all hoses & hydraulic tank, put in new filters and fluid. Ran the tractor on job 4 weeks and now the hydraulic charge light is coming on and the motor dies. Tractor. Will start back up and the hydraulics all work well. Could it be the sending unit at the...

Thanks to mike10 & Gazza & jerry I'm going to make me one of them pullers Hit the side of pin with big hammer popped right out thanks for replys

Mike 10 thanks for the reply the pin in the cylinder is the top pin that holdes the hydraulic cylinder onto the boom arm for the tilt cylinder bucket it has a long bolt that goes through it the 3/4 nut is inside the boom arm on around a 7 in bolt I removed the bolt but not sure on how to get pin...

Does anybody no how to pull the pin out of the upper hydraulic cylinder that goes into boom arm

Took belly pan off pull hydraulic pump had two broken gears flushed lines put new pump On runs good now had to replace one solenoid for foot pedal thanks to everybody

Thanks Mike10 for the information. I checked hydrolic fluid and it's full. Operated auxillary control does not pull motor down. Will remove the pump then let everyone know what I find out. Thanks again.

If foot pedals unlock & move could there be hydrulic line pluged foot Value works when you unplug solenid start engine pedal moves boom Does not move or bucket it does have one pump

I unpluged the solenoids not sensors one at a time the pedal would move on bucket when i unpluged Boom solenoid but pedal was sticky unpluged boom solenoid that pedal was free but if one pedal moves when engine is running how come you have no hydrulics thanks ((/

Did check seal bealt & seat sensor dash lights all work toggle switch is in run postion will sart and move forward & reverse unpluged bucket senser pedal will move but no hydruli. Movement thanks Mike 10

Does anybody think it could have knocked out the pump

Loader will move foward &reverse but no bucket or boom movement. Pedals locked have 10.5 volts at both Boom & bucket sensors. unplug pedal sensor pedal will move plug backend did same on other sensor still No hydrualics for boom or bucket . dash & seat sensors 10.9 volts at conectors