Recent content by Ivan

Help Support SkidSteer Forum:

  1. I

    Need pictures of drive control to help reassemble

    they go into bracke t that is bolted to the top of where the tran mounts to the engine
  2. I

    Looking for suggestions for wear strip on L325 cab

    CONVEYER BELTING AND CUT TO THE SIZE YOU NEED
  3. I

    Power (12V) for attachment (dozer blade)

    Might work but if it was me I would run a seperate feed wire from the battery wit h a heaveir wire
  4. I

    L555 HYDRAULIC BREATHER

    I don't recall seeing any on mine. Check the hyd parts diagram. If thereae any t hey wou dhave to being inside the cab
  5. I

    L555 HYDRAULIC BREATHER

    Your hyd oil is in the chain cases on each side of the machine. On these cases there are inspection covers and may be where it is coming in from. Clean area around these, remove them and reseal. I used permatex on mine and it stopped it
  6. I

    1999 NH LX885 hard start

    Follow your fuel line from injector pump back towards the tank. An elec pump if it has one will be in this line. If yu turn your key on this pump should make a ckicking noise if it is working
  7. I

    1999 NH LX885 hard start

    Does that have an electric fuel pump
  8. I

    Parts suggestions

    Messick's is good. Do a search online for what you are looking for. sometimes a dealer will have these parts and they have had then for so long in sock they want themgone. I bought a complete kit for mine about half price of what local dealer wanted for them and ther were all gen parts
  9. I

    Lx865 weak steering

    If those inspection covers on the case are not sealed you will get water also. Mine had been removed and not resealed when they we re put back on
  10. I

    Lx865 weak steering

    Check on the outside of the chain case and see if there is any where the water could have gotten in at. Usually there is an inspection plate bolted to the op. Check that gasket to see ifit hasbeen leaking
  11. I

    NH LX565 Engine Preheater Not Working

    What is your compression on each cyl
  12. I

    NH LX565 Engine Preheater Not Working

    I would no t buy them from NH unless you have very dep pockets. Take to an auto supply and they should be able to fix you up. I replaced mine and one glow plug from NH was more than I paid for all 4. Another way to check them was shown to me by aNH mahinc that was in his 60's. Take them out and...
  13. I

    LX865 starter turns Hydro pump, but not engine

    Could be some of those good ones from China. I bought a new White tractor and at around 200 hours it sheared all the bolts off the front ring gear. Then again at around 500 same thing. This time I repaired it and had t he bolts tested at work`. They were to soft. One of the engineers did some...
  14. I

    LX865 starter turns Hydro pump, but not engine

    Was there a gasket on there or was it permatex. I would look at the parts diagram and see if NH makes a paper gasket and if so get it.
  15. I

    Lx885 Right side won’t move

See more
Top