Recent content by gokitty199

We are looking at purchasing a flail mower for our little s150 and from reading it outputs around 16.9 gal/min. We are looking at purchasing the flail mower linked down below to help with upkeep for some very rough areas of our property (shoulder high sticker bushes just love to grow here...

thank you everyone, it ended up being the alternator belt, when i went out in daylight i saw that it was ripped and just barely hanging on. replaced that and ran it hard and the machine is running cooler than it ever has been.

no it has not

we have a infrared thermometer so i will try that but where should i check the temperature? im pulling the thermostat off in a few minutes to test it as well as replacing the rad cap if i have one laying around. i have no idea about the water pump/impeller.

pretty much i let it warm up at idle as usual for five minutes or so then i drive a few hundred yards to where im moving dirt before i crank the throttle up, it runs normal and cool for about 3-5 minutes and i can put it under heavy load with no issues, then shortly after that the needle on the...

hello i believe im having a problem with my thermostat on my s150 and was wondering where it was located so i can replace it. any help would be great

i have looked everywhere on the back and front of the bobcat but can not find the fuel shutoff solenoid to save my life. any ideas about where it is located?

well have to check that tomorow, a bird started making a nest and covered the inside of the bobcat with twigs and dead grass. any idea where the solenoid would be located?

we took the bucket off so we could get something made that attaches the the bucket so the skid steer was sitting for about two weeks, it was running great the last time we used it. i went to go start it up today and after a second of it starting i heard three beeps then it shut off, the icon on...

im looking for a ripper but so far ive only been able to find one with one tooth on it. i have a dirtbike track that i will be using it on to chew up the ground ill be running over it with a tiller to keep it soft for when we ride. using just one tooth wont work in the time id need it done. any...