Recent content by fogg

My machine would also start and run fine just would not in gauge the hydraulic function behind the seat behind the AC coil some right hand control wires had been chewed up after I repaired the harness I had the proper control voltage but it wasn't registering in the UCM. I believe it was pin 8...

I had a 1905 &1906 code my UCM was bad

Since then I had a hydraulic line blow and the pressure cut through my fuel tank 🤷

I absolutely have been and so far not any oil used at all the oil level has maintained it's level with no consumption at all I've probably put 25 hours on it since the original situation

This was the exhaust side of the turbo

Good information right there I will definitely remember to keep that in mind. The issue with the muffler I didn't think was a sudden impact I was definitely thinking this was a build up of a long term issue that was literally undetectable until all the aspects came to a head. After I cleared the...

Update on the multi issue situation I bought four new fuel injectors installed them but I believe the bigger problem was the exhaust was totally clogged with black gooey tar stuff it took about 4 hours to clean out the exhaust and the injectors once installed

I started back at square one going over everything again I will admit I'm colorblind so when I examined the fuel I thought it had some off-road mixed in with it then my son stopped by and saw the 2 fuel samples on the bench and brought it to my attention that there was something very wrong with...

I pulled the injectors they look rough

1800 hrs did a filter change 2 weeks ago I have triple checked them and checked fuel for any kind of contamination oil level is in the middle of the high and low marks and is very hard to get started. I took it to bobcat today and they said my entire fuel system is fried. I was so confused on...

Started all at once blowing black smoke and no power