Recent content by flat sk

Have a 742B (Mitsubishi) and I’m a bit oblivious as to the purpose of the resistor? Of the coil? I’ve had the bobcat for about a year have it running well but obviously have to replace the resistor (I think that’s what it is) as it is nearly disintegrated and will eventually short out. If I...

I removed my 4G33 from a 642B last winter. After many days and many failed attempts to uncouple the U joint from the pump splines. what ended up working was a tensioned ratchet strap pulling on the motor and a air chisel wedged between the u joint and pump mount. Eventually jumped right off...

I removed my 4G33 from a 642B this winter. After many days and many failed attempts to uncouple the U joint from the pump splines. what ended up working was a tensioned ratchet strap pulling on the motor and a air chisel wedged between the u joint and pump mount. Eventually jumped right off...

Thanks Zeke. I’ve got a 642B that I’m working my way through. This is greatly appreciated.

Also In addition to the flywheel I need the torque for the 6 bolts that hold the fan/universal assembly to the flywheel. Thanks, Toby

Have a 4G32 that I replaced the ring gear on. I need the flywheel torque spec and weather it asks for locktite? Thanks. I could use a good service manual. The one I bought was at best an operators manual. Thanks in advance. Toby

sorry. Saw the 40 series and was hopeful before fully reading. Hahaha. Mine is a gas pot. 642B. The Mitsubishi 4G32

I’ve been looking unsuccessfully for the last month to find anything less than $725 Canadian plus taxes. Any lead on an alternative would be appreciated.