Recent content by fixingthefarm

Thank-you sir, I will be going there shortly.... My wear plate is seperated, so I need a new one... Thanks again!!!!

thank-you Sir, on my way there....

8875

Seeking hydrostatic pump parts or overhaul kit for a 8875. Any help willo be fine. Thank-you, J.D. dealer no help, going to N.H. next

Anyone know where I may locate hydrostatic pump parts, gaskets, o-rings, seals, wear plates, or a overhaul kit for my J.D. 8875. No luck at J.D. Seeking far and wide for any info.... Thank-you....

Anyone know where to buy hydrostatic pump parts, gaskets, seals, o-rings, wear plates.... or a overhaul kit??? They are off a J.D. No luck at dealer... Didn't check New Holland yet, but looking far and wide to see whats available???? All responses are greatly appreciated. Thank-You

Thank-you for the responce Mike10. I did install a pressure gauge in line, as per the location of the T for the pressure sensor. Only 1 servo control was removed, and it was the opposite pump. And yes it was reassembled correctly. Thanks

Hello to all, new to the site as of this post. Thank-you for looking at my post!!! I have a set of Easton pumps that i removed to put seals in the rears. I also addressed a servo problem. My issue is, after reinstaling the pumps I have no Hydrostatic pressure???? The hydrodrulic pump is working...